• RSS
  • Facebook
  • Twitter
  • Linkedin
Home > Lenovo Laptop > Flex 14 Headphone Jack/Audio Issue

Flex 14 Headphone Jack/Audio Issue


LG G3 headphones fix: Install a volume control app Another workaround rather than a fix, and one that we have seen reports of working only moderately well. although it sounds like that, it's being made by the internals of the phone. 2. javamonk - 06/26/2014 Reply Agreed, mine was stuck inside of the back cover fidelvila - 07/22/2014 Reply So was mine - thanks for telling! Posts: 1 Registered: ‎09-27-2014 Location: Canada Message 3 of 5 (5,078 Views) Re: Flex 14 Headphone Jack/Audio Issue Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email

You remove the contact, the contact point (underneath) sits on the board. Please help! I managed to pull everything back into line using the screws, but the QC on these replacement batteries is a bit suspect. bluezzer - 10/29/2013 I did not remove the battery to do a Speaker replacement and had no issues with getting the Speaker out/in.

Lenovo Laptop Headphone Jack Not Working

Replacement dock connector - Buy white dock, Buy black dock Suction cup - Buy now 5-point security screwdriver - Buy now Standard #000 Phillips screwdriver - Buy now Spudger tool - After cleaning all parts with isopropyl alcohol it still didn't work. We'll not near me, go over there...

  • good to go.
  • If so try that one.
  • I attempted the removal but decided not to in the end.
  • Scroll down to the bottom and select 'Factory Data Reset'.
  • Sent from my iPhone using Tapatalk I don't think any android phones have audio out thought the a usb connection (at least without some major modifications or rooting).
  • Carefully re-position the display shield over the cables once you're sure they are secure.
  • I then attached the 1.7mm (lower) screw loosely, removed the Pentalobe driver gently, and inserted the 1.5mm (upper) screw into the assembly.
  • Remove the rear camera from the iPhone.
  • Nothing happened when I turned it on.

amorteguy - 01/20/2014 Reply TO ALL WITH NETWORK PROBLEMS! For the record, I ignored this advice. Be sure to break them first. 6. Lenovo Sound Driver Its my moms house so of course she's got gross brown carpet.

stephane lecreux - 05/09/2014 Reply Top screw didn’t move with iFixit Philips #000 driver. Audio Combo Jack Visit eBay's page on international trade. Putting it back in, however, was very easy and didn't require any significant effort. click for more info I guess your saliva completes the circuit long enough to get it to work.

tallismanproductions - 12/02/2014 Reply Pressure contact needs to be remain EXACTLY in the same position if you remove/replace battery. Realtek Audio Driver Windows 10 Not for audio quality of course but to solve this issue. ←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗Tap that kudos button if I helped ^^←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗←↑→↓↘↙↖↗ This helped me too 1 Kudo Reply FatimaB What's DOS? Now what?

Audio Combo Jack

Then, I worked it from the bottom to the top. It took an hour to unscrew after the screwdriver from the kit stripped the screw. Lenovo Laptop Headphone Jack Not Working Once the date and time is synced you will need to turn airplane mode off and one as it may display 'Searching... 3G' or if it still says searching (which most Lenovo Laptop Sound Not Working Windows 10 Do NOT use excessive pull force else it'll deform the battery and reduce the capacity. 2) If the pull test didn't work, then get a hot air gun on medium and

Worked well and saved a lot of time. news As I figured out - that is the SMD capacitor. I mean, what's up with that? I managed to tear it just a tiny bit in the curve of the cable too. Lenovo Laptop No Sound

Now use your spudger tool to pry up the three cables that attach the display to the board. None is guaranteed to fix the problem, although with luck my LG G3 seems to be back to its best, and I used only tips 1 and 3. The other was over some large brown sheet of unknown function (though I think it goes over the battery). have a peek at these guys I tend to think this is the equivalent of switching it off and switching it on again, but if there is a software bug it may help.

Go to Settings > General, and then Backup & Reset. Realtek High Definition Audio Driver Sort of... Simply factory reset your phone.

I have one of these(Lowrider Navy/Chrome), and while it works fine with my Laptop[Lenovo Y565), it needs a separator Audio/mic Separator to use the Microphone.

I know that somewhere is short-circuit but dont know how to solve it. You're not going to completely lift it out and remove it. Lucasa Clearman - 02/03/2016 Reply Add a comment Add Comment 1024 Step 4 Battery Edit Remove the following screws securing the battery connector to the logic board: One 1.7 mm Phillips Lenovo Drivers Push in.

It stripped the ne 1.7 mm Phillips screw circled in red in the photo above. Look at the other guides for the 4S they show the 4 screws and how to lift the shield out, take out the camera etc. How can I work on my phone if its covered in dirt? check my blog Sorry, the auction has ended and you were outbid.

Lift the cable cover from its edge nearest the top and remove it from the iPhone. 3 comments If you just very slightly twist this plate clockwise as you are lifting In the end I had to use the plastic tools to gently lever the battery away, working from the outside edge and ensuring I wasn't levering against the volume control buttons. Once I had the back off I loosened all the screws then turned it upside down and shook the crap out of it. jurajtomecek7 - 01/28/2015 Reply I used my 16x magnifier loupe to be certain I had the pressure sensor aligned with the screw hole - no problem, no stripping.

Donc il ne faut pas la tordre. Forget it... The G3 "sees" a load there and hooks up. 07-28-2014 03:42 PM Like 0 290 mmohn01 I use a pair of Yurbuds Explorer headphones, and they sound great. The G3 ahs a cute little algorithm that tries to let the internals know if it is being connected to a headphones or an auxiliary input.

It's much easier to remove the wifi antenna flex from the board using the blue spudger if the board/PCB is still secured with the 4.8mm screw. This clip is attached only by the upper screw. James Molyneux - 06/05/2012 Reply I also had a small black and gold connector held down by the top screw on this step. Reassemble and .....

This is a private listing and your identity will not be disclosed to anyone except the seller. Maynard Stevens - 11/12/2013 Reply The black & copper contact piece is missing from my iPhone. More DIY help and guides If you run into problems, be sure to check out our iMore forums for answers to commonly asked questions. vulturul21 January 4, 2013 6:05:55 PM I tested the adaptor on another device with a 3 layers jack (not combo like laptop) and worked just fine zdbc13 a b D Laptop

And it is without any instruction step removed in STEP 12? Apparently the AUX circuitry is very finicky and rejects minor differences in impedance/resistance created by either the cord or the front end of the stereo itself. I used a straightened paper clip held with a (really good) pair of needle nose pliers and pushed straight in until it fully popped out. If you're still having issues, rake your carrier over the coals Posted via Android Central App This is my second phone.

The "ground-loop" cord tries to solve the problem from that approach. When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. Posts: 1 Registered: ‎02-03-2014 Location: Ireland Message 1 of 5 (5,583 Views) Flex 14 Headphone Jack/Audio Issue Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to