• RSS
  • Facebook
  • Twitter
  • Linkedin
Home > Dvd Drive > DVD Drive Will Not Read Dvd Or Burn In Windows 8.1

DVD Drive Will Not Read Dvd Or Burn In Windows 8.1

Thank you for sharing your knowledge. You can reinstall your CD or DVD writing or recording software. Above "Class", there is an entry which says (Default) and in that same line under the heading Data,it is mentioned as (value not set).The DVD drive icon is seen under ---- Select Boot Options, then press Enter. Source

Plastic discs can be easily scratched and the data on the disc can be destroyed if left in the sun. Figure : Removing the side panel Gently disconnect both the data cable and the power cable from the back of the CD/DVD drive. In Windows, search for and open Device Manager. On the top-right corner, in the Search box of Control Panel, type troubleshooter, and then click Troubleshooting.

HP PCs - CD/DVD Drive Is Not Detected (Windows 10, 8) This document applies to HP and Compaq computers with Windows10 or 8. Sign up now. Thanks again!

This can damage the optics inside the drive and make matters much worse. Figure 12: Uninstall DVD/CD-ROM drive in Device Manager Click Yes or OK to remove the drive listing, and then close Device Manager. If you get any prompts from User Account Control while running the Hardware and Devices troubleshooter, click Yes. I don't remember if this was the way in Windows Xp which i had before.DVD drive do show up in the device manager .Under properties in DVD drive ---- DVD Region

I can't find it. How does integer type cast behave in Java for numbers beyond the range of integers? WORKED FOR ME......... HP Customer Support Support Home Products Software and Drivers Forums Contact Support Search Select your Model Let HP find my products Identify now HP can identify most HP products and recommend

Step 5: Reinstalling the CD/DVD drive in Device Manager in Windows 8 Use the following steps to remove and reinstall the drive name in Device Manager: Remove any discs that may If yes, proceed to the next step. Turn on the computer and immediately press the F10 key repeatedly until the BIOS Setup Utility screen appears. Join them; it only takes a minute: Sign up Here's how it works: Anybody can ask a question Anybody can answer The best answers are voted up and rise to the

Be careful not to dislodge other cables. Most home electronics stores offer repair and cleaning kits for discs at minimal cost. Fixing the CD/DVD problem simply involves deleting the filter entries for the third-party device drivers. Make sure you have selected this exact key name.

Click LowerFilters only. this contact form all it did was delete the cd burning software from itunes, which means I need to reinstall itunes or I cannot burn any cds. The driver may be corrupted or missing. (Code 39) Windows successfully loaded the device driver for this hardware but cannot find the hardware device. (Code 41) The instructions below can be note: If the CD/DVD writing software that you use was purchased separately, uninstall the software, restart, then use its installation discs to install the software, then restart again.

I had the same problem on my computer and I tried everything in vain. If the drive name still does not appear, replace the cable, the drive, or have the computer serviced. Click Yes when you receive the following message: Are you sure you want to delete this value? My dvd drive works, but reading or burning cds still isn't functioning.

PCuser6Jan 28, 2014, 8:59 AM xcrossroadsx said: This is often caused by one of two things: a bad drive, or a bad filter driver. Helpful +7 Report thankfulll Jan 5, 2010 at 07:22 PM THANK YOU SO MUCH! This could be a scam; do not provide any personal information.

You may have to restart the computer.

I tried safe mode and it doesnt work either. Step 4: Resetting the computer power Under certain conditions the drive might lose communication with Windows even after restarting Windows, which can cause problems with CD or DVD detection. It is possible it is something else, but in most cases it is not.Good luck. To do this, go to "Step 3: Delete the LowerFilters registry entry." 6.

Scan for hardware changes again to attempt to detect the drive. Use the following steps to reinstall the drive in Device Manager and to find if Windows is able to recognize the drive. Want a foolproof procedure please. Check This Out If we eliminate the second we should know which of the two it is.To fix a bad filter driver, do the following:1) open regedit.exe by typing "regedit" without quotes into the

On a desktop computer Press and hold the power button for 5 seconds to turn your computer completely off. After waiting at least 10 seconds, reconnect power to the computer. Figure : Example of CD/DVD drive listing in BIOS Press the Esc key to exit Device Configuration. If a LowerFilters value is listed on the right side of the registry editor window, click the LowerFilters value, and press the Delete key.

If you get any prompts from User Account Control while running the Hardware and Devices troubleshooter, click Yes. Back to Top For any other issue with the CD, DVD or Blu-ray drive on your computer, refer to the Dell knowledgebase article Troubleshooting CD/DVD or Blu-Ray Drive Problems in Microsoft But there is no "UpperFilters" or "LowerFilters" seen.So nothing to delete. Use the steps in this document to troubleshoot problems with CD and DVD drives reading discs.